1988 Correct Craft Fish Nautique for Sale

Contact info 903-509-1754 office, or 903-253-8658 cell I am selling my 1988 Fish Nautique. I am asking 42k, but I will accept any reasonable offer. I am selling because we purchased a bigger boat, and the Fish did not get used this year. I used her the summer of 2017, and 2018. She sat through 2019, though I did start and run her twice a month. We used her in fresh, and salt water. I would say she has a 30 mile safe offshore range, though she has been 60 miles into the gulf. I usually just fished her within Texas state waters (9 miles) offshore. I started working for the Nautique warehouse in Northeast Texas in 1992. I know am part owner in the Nautqiue dealership in Tyler, TX. I have always wanted a Fish Nautique, and finally acquired this one in the fall of 2016. Through the fall, winter, and into late spring, I refurbished this boat. There are way to many items to list that were replaced, but I will attempt to include everything. Bottom gear: Prop Rudder port Strut bushing Shaft Shaft log Drive train: rebuild for GT-40 310 hp mpfi raw water pump circulating water pump pullies belts all hoses closed cooling system distributor spark plugs wires cap rotor low pressure fuel pump high pressure fuel pump (fuel control cell) fuel injectors PCM 1.23:1 Transmission Resealed transmission New pump Helm The dash plaque was re-anodized, but it faded quickly New gauges all New wiring (stem to stern, engine, dash, battery cables, every inch of wiring is new) steering head steering cable Electronics 2 simrad go9 plotters 2 total scan transducers 1 simrad vhf radio (registered with mmsi) 1 handheld vhf radio (registered with mmsi) Bilge area: 2 bilge pumps 2 blowers all seacocks mufflers exhaust hoses exhaust flaps engine motor frame Misc: seadek trailer cup holders bimini top that goes over the bow (all stainless hardware) anchor, anchor rode, and 250' of rope bow anchor roller bow lights rub rail is original, but the rope insert is new under water lights. windshield The list goes on. I have over 70k invested in her. I have photo documentation of the refurbish. There are a few simple things I have not addressed yet. I have not installed new latches on the lids, which you will see in the photos. I wanted to rebuild the dry box above the helm too. Finally, I wanted to, but never replaced the plastic access hatches. The Gelcoat is original too, so keep in mind there are some chips, cracks, and crazing. I also have some things that will go with her. spare prop original driver, and passenger seats (I never installed them because I wanted to install a leaning post) original interior cushions (from 1988, though still in decent shape) (we never used the cushions, they stayed in storage) kicker motor bracket We encourage any potential buyers to come view her in person, and take her on a test ride!