1999 Shamrock Pilothouse for Sale
Next Ad »Make
Shamrock
Type
Powerboats
Model
Pilothouse
Length
20'
Hull material
Fiberglass
Year
1999
Class
Pilothouse 1
Fuel type
Gas
Engine type
inboard
Name
Shamrock Pilothouse 1999
Location
Price
$39,000
1999 Shamrock Pilothouse
Rebuilt 20’ Shamrock
Pilothouse. This vessel has been gone
through extensively. Pretty every
screw, nut, bolt or hardware has been
touched, removed or replaced. Boat is
100% ready for the water. Serious
buyers only please.
Electronics
• Garmin GLD 30A XM Radio Weather
Module
• Garmin GMR 18k Radar Dome
• Seaview Radar Mount
• Garmin 4212 Multifunction
chartplotter (12â€)
• Garmin GSD22 Sounder
• Airmar Triducer B744V 50/200kHz
Transducer
• Standard Horizon GX1200 VHF
• New Sony M100BT receiver unit
with XM and Bluetooth
• New 180W 32†LED curved light bar
(1 on front of pilot house)
• New 18W LED floor lights (2 on
read of pilot house)
• New red LED under gunnel rope
lighting
• Remote spotlight
• Various new rocker switches
• New breakers
• New Sudbury switch
• New batteries
• New Heater Craft heater with new
switch
• New gauges
• New bus bars
• 95% of the boat has been
rewired
Pumps and Hoses
• New hoses for bilge, macerator
and raw water wash down pumps
• New live well pump
• New macerator pump
• New valves for all pumps
• New thru hull fittings for all
pumps
• Bennett trim tabs with new
pump
Steering
• Sea Star hydraulic steering
• New steering cylinder
• New rudder stuffing box
Fuel System
• New fuel tank
• New sending units
• New fuel lines from fill to tanks
to fuel pump
• New Groco 6 port fuel tank
valve/switch
• New bilge paint in fuel tank
cells
Hull
• All thru hull and hardware was
removed from boat.
• Keel was sanded, filled with
Petit EZ-Bond High Strength Marine
Bonding
Epoxy, then fiberglassed and
prepped for paint.
• Bottom of boat was soda blasted,
sealed with Interlux Interprotect 2000E
Barrier
Coat
• 3 coats of Petit Bright Red
Anitfouling bottom paint
• All below waterline fittings were
replaced with new or sandblasted and
reinstalled with 3M 5200 Marine
Adhesive
• The hull above the waterline
Gelcoat was completely sanded, sealed,
primed,
painted with 4 coats of Awlcraft
2000 Arcylic Flag Blue, wet sanded
between
coats
• Final coat was wet sanded in 3
stages, buffed and waxed to mirror finish
• Rub Rail was removed, all screw
holes were countersunk and filled with 3M
marine epoxy
• Original Rub Rail base
reinstalled with new Taco Marine insert
• 3 aft deck covers were skinned,
new Coosa board and fiberglassed
• Beckson Pry-Out inspection ports
installed over fuel tank sending units
• Bow floor hatch also received new
Coosa board and new hinges.
• New under hood soundproofing
• New engine compartment blower
with hose
Engine
• 750 hours on 350 Marine Power TBI
engine
• Rebuild done at 600 hours with
Jasper Long Block
• New Thermostat
• New heater hoses
• New top exhaust hoses
• New raw water hose from inlet to
cooler
• New throttle position switch
• New MAP sensor
• New idle air control
• New stuffing box for prop
shaft
Trailer
• 2009 Venture Aluminum roller/bunk
trailer
• LED lights
• Brakes on both axles
• New wood
• New 2" coupler
• Custom rear support for Shamrock
Keel